Full-scale LEAP Fan Blade-Out Rig Test Yields Outstanding Results; Advanced LEAP Fan Endurance Test Nearing Completion
LE BOURGET, France— 20 June 2011— Testing of CFM International's advanced 3-D Woven Resin Transfer Molding (3-DW RTM) fan is proceeding on schedule and the company is achieving outstanding results.
In May, CFM completed a full-scale fan blade out rig test, simulating certification requirements for the proprietary 3-DW RTM technology. The company has also completed extensive full-scale component tests, including bird ingestion testing with the same very positive results.
"The fan blade out test went beautifully," said Bastin. "The fan experienced very low overall unbalance and behaved as we had predicted in pre-test simulations. We also included the composite fan case, which showed no cracks or stress defects and all parts were contained. This test was a total success and confirmed that the LEAP fan will meet all certification requirements. "
Endurance testing of 3-DW RTM fan is also proceeding on schedule, with 3,500 of the planned 5,000 cycles completed. The demanding test was designed to evaluate fan behavior within a real thermal and vibratory environment. The results have been outstanding, meeting or exceeding all pre-test predictions.
"The endurance test is an important one for us because it addresses the conditions that our customers will eventually see in operation," said Francois Bastin, director of the LEAP Program for CFM. "With only 1,500 cycles to go, we have seen absolutely no change whatsoever on the fan blades. We couldn't be happier with the results."
CFM initiated ground test of a full-scale 3-DW RTM fan installed on a CFM56-5C MASCOT (Moteur à Aubes de Soufflante en COmposite Taille) demonstrator engine in early 2009 to validate the RTM technology.
Prior to launching the endurance test earlier this year, the MASCOT engine completed aerodynamic and performance testing at Snecma (Safran group) facilities in Villaroche, France, before being sent to GE facilities in Peebles, Ohio. It has successfully logged more than165 hours of extensive crosswind and acoustics testing to measure noise levels under various operating conditions. MASCOT will accumulate approximately 400 additional hours full-scale by year-end.
The LEAP engine is on track for certification in 2014 and entry into service in 2016.
CFM International is a 50/50 joint company between Snecma (Safran group) and GE. It is the world's leading producer of commercial aircraft engines, with more than 22,200 delivered since the company's formation in 1974.
Jamie Jewell - 513.552.2790 - firstname.lastname@example.org - Mobile : 513.885.2282
Rick Kennedy - 513.243.3372 - email@example.com - Mobile : 513.607.0609
Antoinette Menard - 220.127.116.11.09.28 - firstname.lastname@example.org - Mobile : 18.104.22.168.10.65