Test Equipment Engineer

Job Location: Twinsburg, Ohio

The Project Engineer II will be responsible for the development of test equipment and/or test equipment software for state-of-the-art electrical and electronic designs for use in commercial and military fixed-wing aircraft and rotorcraft. This role will originate specifications for test equipment and/or test equipment software along with its design documents, verification/validation plans and procedures, software, reports, or other documentation in support of such test activities.

Essential Duties and Responsibilities:
•Design, document, and commission test equipment and test equipment software for use in acceptance of aerospace equipment
•Perform test equipment troubleshooting or comissioning
•No travel requirements
•Adhere to safe work practices and contributes to the evolution of the health, safety, and environmental program and culture
•Other duties may be assigned

Physical Demands:
The physical demands described here are representative of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.
•While performing the duties of the position, the employee is regularly required to sit, use hands and fingers, handle and feel, and reach with hands and arms
•The employee will occassionally lift and/or move objects up to 25 pounds

Work Envornment:
The work environment characteristics described here are representative of those an employee encounters while performing the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions.

The work environment is split between office and laboratory work, with most work being performed in the office. The noise level in the office is typically quiet while the noise level in the lab can occassionally require hearing protection.

This position requires use of information or access to hardware which is subject to the International Traffic in Arms Regulations (ITAR). All applicants must be U.S. persons within the meaning of ITAR. ITAR defines a U.S. person as a U.S. Citizen, U.S. Permanent Resident (i.e. “Green Card Holder”), Political Asylee, or Refugee.

Education and/or Expierence:
•Design, document, and commission test equipment and test equipment software for use in acceptance of aerospace equipment
•Perform test equipment troubleshooting or comissioning
•No travel requirements
•Adhere to safe work practices and contributes to the evolution of the health, safety, and environmental program and culture
•Other duties may be assigned

Knowledge/Skills:
•Experience with test equipment as related to electronics
•Experience with AutoCAD or other software for schematic and test equipment documentation
•Experience with LabVIEW programming and integrated peripherals
•Hands-on experience with typical electrical test and measurement equipment
•Ability to demonstrate analytical problem solving
•Strong project management and oraganizational skills
•Strong communication and team-building skills
•Ability to function in a fast-paced environment with minimal supervision

Prefferd Skills:
•Experience designing, building, and commissioning automated test equipment and/or test equipment software
•Experience with programming / troubleshooting PLCs

No travel requirements